Subject	Struggling with A/C low cut sensor issue, any A/C experts?
Posted by	Polishzx on July 05, 2020 at 9:52 PM
	This message has been viewed 250 times.
Message	Trying to charge my A/C system for the first time. Had everything setup and through the process until I needed the compressor to work to take in refrigerant. Unfortunately the compressor won't turn on. I jumpered the switch sensor connector, and the compressor comes on fine. I replaced the switch with a new one, SAME ISSUE. It still doesn't come on, but comes on when jumpered. What else could cause this, any ideas? This is a 94TT so working with R134a. A brand new drier was also installed recently. Could there be debris in the line or something else causing an issue? I have a ConZult and that says there are no detected problems with the A/C....
Follow Ups	Struggling with A/C low cut sensor issue, any A/C experts? - Polishzx 21:52:00 07/05/20 The AC does not Pull the Refrigerant in - Cjw3 06:46:57 07/06/20 So I guess my issue is low pressure side is not taking charg - Polishzx 11:55:47 07/06/20 '94 is a Native R134.. Yes? - Cjw3 12:21:18 07/06/20 Correct, native r134a on a 94. It seems like the valves can - Polishzx 13:04:14 07/06/20 I would think the Clog would effect Vacuum - Cjw3 14:12:01 07/06/20 Schrader valve - megaDan 08:22:14 07/07/20 harbor freight manifold gauges? (n/m) - slayer fan 15:15:58 07/06/20 if so, my quick disconnects were mislabled for - slayer fan 15:31:01 07/06/20 I am using the harbor freight manifold gauges! - Polishzx 16:25:27 07/07/20 yours appears to be correct. turning the valve to - slayer fan 17:19:00 07/07/20 also, when adding r134,the high side valve on the - slayer fan 17:55:36 07/07/20 Re: Struggling with A/C low cut sensor issue, any A/C experts? - Metacom 21:01:07 07/06/20 Re: Struggling with A/C low cut sensor issue, any A/C experts? - xarcos 15:21:17 07/07/20
Post a Followup	You cannot reply to this message because you are not logged in.