Subject	Re: Front Control Arm Bushing Removal?
Posted by	itsa300zx on May 26, 2020 at 11:47 AM
	This message has been viewed 158 times.
In Reply To	Front Control Arm Bushing Removal? posted by lleron on May 25, 2020 at 05:58 PM
Message	I just used some parallel spacers to raise the "flange" areas. I also fit some spacer blocks in between the channel (near both sides of the bushing) to prevent sides from collapsing when pressing on them.
Follow Ups	Front Control Arm Bushing Removal? - lleron 17:58:09 05/25/20 Re: Front Control Arm Bushing Removal? - itsa300zx 11:47:00 05/26/20 Re: Re: Front Control Arm Bushing Removal? - lleron 11:41:27 06/01/20 Good information to know on the bushing removal !!! - JULIAN 20:17:36 06/01/20 Heat, vice, and a chisel (n/m) - JerseyTex 13:28:03 05/26/20 I build Nismo loaded arms - it's a suck ass process. - Bernie (NoVA) 02:10:12 05/27/20 Re: I build Nismo loaded arms - it's a suck ass process. - lleron 15:32:37 05/27/20
Post a Followup	You cannot reply to this message because you are not logged in.