Subject	If you haven't seen this yet, here are two handy guides
Posted by	Jinjiro on April 20, 2020 at 12:49 PM
	This message has been viewed 292 times.
In Reply To	Thanks so much! And the LEDS are what I am doing. (n/m) posted by SirpriZ on April 20, 2020 at 11:12 AM
Message	How to replace the OEM control pod lamps with LED lamps Cluster bulb conversion writeup LED or PIAA One note - Despite what the first writeup says, I did not need to re-wire any of the LEDs. All of the Neo wedge LEDs I bought were plug & play, so my guess is something has changed since this was written in '09. Below is what I purchased. I started with the natural white, but didn't like how they looked and switched to cool white. Hope this helps. Instrument Cluster 194 5 SMD LED Tower in Cool White x 4, Amber x 1, Red x 1 74-NWHP3: Natural White x 8 NEO5-WHP: 5mm NEO5-xHP Cool White x 4 Climate Pod NEO3-WHP: 3mm NEO3-xHP Cool White x 1 NEO5-WHP: 5mm NEO5-xHP Cool White x 2 Lighting Pod NEO4-WHP: 4mm NEO4-xHP Cool White x 5 Interior (Floor, Map, Ignition) 74-NWHP3: Natural White x 5 Interior (Dome) 3110-CW18-CB: Cool White x 1
Follow Ups	Would anyone know the bulb numbers for the following - SirpriZ 15:30:11 04/19/20 Re: Would anyone know the bulb numbers for the following - Jinjiro 08:29:41 04/20/20 Thanks so much! And the LEDS are what I am doing. (n/m) - SirpriZ 11:12:38 04/20/20 If you haven't seen this yet, here are two handy guides - Jinjiro 12:49:08 04/20/20 That's really helpful, thanks again. (n/m) - SirpriZ 16:46:31 04/20/20
Post a Followup	You cannot reply to this message because you are not logged in.