Subject	How long was it sitting for? Sounds like lifters to me
Posted by	itsa300zx on February 24, 2020 at 9:16 PM
	This message has been viewed 163 times.
In Reply To	Got project running, but it has low compression. Need advice posted by Polishzx on February 24, 2020 at 06:34 PM
Message	Try pouring a couple spoons fulls of ATF in the cylinder and let it soak for a couple days. May loosen up the rings.
Follow Ups	Got project running, but it has low compression. Need advice - Polishzx 18:34:36 02/24/20 hard to tell in video, but sounds top end to me - Stanky (BC) 20:35:32 02/24/20 Yeah it is tough to pick up, but it is fairly loud - Polishzx 22:27:05 02/24/20 How long was it sitting for? Sounds like lifters to me - itsa300zx 21:16:01 02/24/20 Not for too long, bit over a year. - Polishzx 22:28:29 02/24/20 My opinion is its top end clatter - Cjw3 21:22:09 02/24/20 Yeah, I wasn't sure what it could be - Polishzx 22:38:27 02/24/20 You probably have a slightly bent rod from hydrolock. - Bernie (NoVA) 01:26:49 02/25/20 Would the compression go back up after putting oil in cyl? - ZXoltan 11:53:27 02/25/20 Sub 100psi is typically when you really feel a miss. (n/m) - Bernie (NoVA) 13:38:17 02/25/20 I can try again with a smaller amount of oil - Polishzx 14:01:56 02/25/20 I'll definitely try it, thanks for feedback - Polishzx 14:01:21 02/25/20 Agree. Does sound like bent rod clap. See video in comments - volcomstone550 05:53:04 02/26/20 Based on your diagnostic work (well thought out and - SirpriZ 14:25:23 02/25/20 If its a bent rod you can fix it relatively easy. - volcomstone550 05:59:54 02/26/20
Post a Followup	You cannot reply to this message because you are not logged in.