Subject	I'm curious on the length of the Al drive shaft.
Posted by	itsa300zx on February 06, 2020 at 11:39 AM
	This message has been viewed 115 times.
In Reply To	It's out... posted by MyBlueZ on February 02, 2020 at 03:08 PM
Message	My Z1 single piece out out of the car and can measure for reference if you'd like.
Follow Ups	1 piece driveshaft removal - MyBlueZ 17:31:21 01/25/20 Hopefully you've got the driveshaft out by now. If not, here - SirpriZ 13:32:37 01/27/20 Re: Hopefully you've got the driveshaft out by now. If not, here - MyBlueZ 16:18:52 01/27/20 I think that's a good idea. See if you agree with this - SirpriZ 21:19:08 01/27/20 Why would you do all that work to move the engine and trans. - itsa300zx 09:49:36 01/28/20 It's not a huge amount of work. Moving a rear subframe would - Ghoztt 11:15:33 01/28/20 How would unbolting the diff allow for rearward travel of - SirpriZ 13:30:13 01/28/20 I was thinking of dropping the diff nose downwards??? (n/m) - itsa300zx 14:27:09 01/28/20 Re: I think that's a good idea. See if you agree with this - MyBlueZ 13:25:01 01/28/20 You shouldn't need to go that in depth. You did remove - Ghoztt 21:54:43 01/27/20 Re: You shouldn't need to go that in depth. You did remove - MyBlueZ 13:21:11 01/28/20 Good luck and follow up with us. Either get another DS or - SirpriZ 20:01:59 01/28/20 It's out... - MyBlueZ 15:08:56 02/02/20 Well done! (n/m) - SirpriZ 12:39:34 02/03/20 Get a new DS while it's out. That is too much time wasted on - Ghoztt 08:50:02 02/06/20 I'm curious on the length of the Al drive shaft. - itsa300zx 11:39:53 02/06/20 Re: I'm curious on the length of the Al drive shaft. - MyBlueZ 18:42:41 02/06/20
Post a Followup	You cannot reply to this message because you are not logged in.