TwinTurbo.NET: Nissan 300ZX forum - Why would you do all that work to move the engine and trans.
Subject
Why would you do all that work to move the engine and trans.
Posted by
itsa300zx
on January 28, 2020 at 9:49 AM
This message has been viewed
160
times.
In Reply To
I think that's a good idea. See if you agree with this
posted by SirpriZ
on January 27, 2020 at 09:19 PM
Message
would it not be easier to unbolt the diff?
Follow Ups
1 piece driveshaft removal
-
MyBlueZ
17:31:21 01/25/20
Hopefully you've got the driveshaft out by now. If not, here
-
SirpriZ
13:32:37 01/27/20
Re: Hopefully you've got the driveshaft out by now. If not, here
-
MyBlueZ
16:18:52 01/27/20
I think that's a good idea. See if you agree with this
-
SirpriZ
21:19:08 01/27/20
Why would you do all that work to move the engine and trans. -
itsa300zx
09:49:36 01/28/20
It's not a huge amount of work. Moving a rear subframe would
-
Ghoztt
11:15:33 01/28/20
How would unbolting the diff allow for rearward travel of
-
SirpriZ
13:30:13 01/28/20
I was thinking of dropping the diff nose downwards??? (n/m)
-
itsa300zx
14:27:09 01/28/20
Re: I think that's a good idea. See if you agree with this
-
MyBlueZ
13:25:01 01/28/20
You shouldn't need to go that in depth. You did remove
-
Ghoztt
21:54:43 01/27/20
Re: You shouldn't need to go that in depth. You did remove
-
MyBlueZ
13:21:11 01/28/20
Good luck and follow up with us. Either get another DS or
-
SirpriZ
20:01:59 01/28/20
It's out...
-
MyBlueZ
15:08:56 02/02/20
Well done! (n/m)
-
SirpriZ
12:39:34 02/03/20
Get a new DS while it's out. That is too much time wasted on
-
Ghoztt
08:50:02 02/06/20
I'm curious on the length of the Al drive shaft.
-
itsa300zx
11:39:53 02/06/20
Re: I'm curious on the length of the Al drive shaft.
-
MyBlueZ
18:42:41 02/06/20
Post a
Followup
You cannot reply to this message because you are not
logged in
.