Subject	You shouldn't need to go that in depth. You did remove
Posted by	Ghoztt on January 27, 2020 at 9:54 PM
	This message has been viewed 169 times.
In Reply To	Re: Hopefully you've got the driveshaft out by now. If not, here posted by MyBlueZ on January 27, 2020 at 04:18 PM
Message	the exhaust, right? (just making sure) It should slide quite a bit at the end of the output shaft on the trans to free up enough space. Is there something blocking the driveshaft from sliding forward towards the front of the car? 1993 Nissan 300ZX Slicktop 1992 Nissan Skyline GT-R Gunmetal Gray - Long Live the Z and Godzirra! - "Love cars. Love people. Love life." - Mr. K.
Follow Ups	1 piece driveshaft removal - MyBlueZ 17:31:21 01/25/20 Hopefully you've got the driveshaft out by now. If not, here - SirpriZ 13:32:37 01/27/20 Re: Hopefully you've got the driveshaft out by now. If not, here - MyBlueZ 16:18:52 01/27/20 I think that's a good idea. See if you agree with this - SirpriZ 21:19:08 01/27/20 Why would you do all that work to move the engine and trans. - itsa300zx 09:49:36 01/28/20 It's not a huge amount of work. Moving a rear subframe would - Ghoztt 11:15:33 01/28/20 How would unbolting the diff allow for rearward travel of - SirpriZ 13:30:13 01/28/20 I was thinking of dropping the diff nose downwards??? (n/m) - itsa300zx 14:27:09 01/28/20 Re: I think that's a good idea. See if you agree with this - MyBlueZ 13:25:01 01/28/20 You shouldn't need to go that in depth. You did remove - Ghoztt 21:54:43 01/27/20 Re: You shouldn't need to go that in depth. You did remove - MyBlueZ 13:21:11 01/28/20 Good luck and follow up with us. Either get another DS or - SirpriZ 20:01:59 01/28/20 It's out... - MyBlueZ 15:08:56 02/02/20 Well done! (n/m) - SirpriZ 12:39:34 02/03/20 Get a new DS while it's out. That is too much time wasted on - Ghoztt 08:50:02 02/06/20 I'm curious on the length of the Al drive shaft. - itsa300zx 11:39:53 02/06/20 Re: I'm curious on the length of the Al drive shaft. - MyBlueZ 18:42:41 02/06/20
Post a Followup	You cannot reply to this message because you are not logged in.