TwinTurbo.NET: Nissan 300ZX forum - Should be no gap between the slinger and upper plenum bolt.
Subject
Should be no gap between the slinger and upper plenum bolt.
Posted by
itsa300zx
on January 17, 2020 at 10:20 AM
This message has been viewed
250
times.
In Reply To
The engine slinger, am I doing it correctly?
posted by dancefloor
on January 17, 2020 at 12:15 AM
Message
When bolted on properly the slinger will be parallel to the top of the engine. Might need to be flipped around, short end goes to the back IIRC.
Follow Ups
The engine slinger, am I doing it correctly?
-
dancefloor
00:15:43 01/17/20
Should be no gap between the slinger and upper plenum bolt. -
itsa300zx
10:20:07 01/17/20
Also need to remove the throttle wire & guide. (n/m)
-
jzack
10:02:17 01/19/20
Post a
Followup
You cannot reply to this message because you are not
logged in
.