Subject	Re: Where did you get the gear? Are you sure it is the right >>
Posted by	itsa300zx on January 14, 2020 at 4:08 PM
	This message has been viewed 159 times.
In Reply To	Where did you get the gear? Are you sure it is the right >> posted by ZUL8TR on January 14, 2020 at 03:14 PM
Message	Agreed, measure both shaft and ID of Gear. Tolerance is a tight fit but don't need to be pressed on, at least for the hand full of new gears that I've installed. Usually have a harder time of removing them, as you've experienced.
Follow Ups	Timing crankshaft gear wont go back in. - slcZ32 11:08:42 01/14/20 Maybe try it without the woodruff key first.. - itsa300zx 12:17:50 01/14/20 Re: Maybe try it without the woodruff key first.. - slcZ32 14:04:18 01/14/20 Where did you get the gear? Are you sure it is the right >> - ZUL8TR 15:14:14 01/14/20 Re: Where did you get the gear? Are you sure it is the right >> - itsa300zx 16:08:20 01/14/20 If you stressed the Crank getting Off the Oil Pump (BTDT) - Cjw3 07:25:32 01/15/20 Re: If you stressed the Crank getting Off the Oil Pump (BTDT) - slcZ32 15:30:48 01/15/20 Most likely deformed the gear getting it off. - ZXoltan 14:35:22 01/17/20 The gear is not overly hard metal, maybe you deformed it - itsa300zx 15:41:15 01/15/20
Post a Followup	You cannot reply to this message because you are not logged in.