Subject	Crank pulley backing plates Orientation
Posted by	nonstopna on December 31, 2019 at 9:43 PM
	This message has been viewed 219 times.
Message	Im looking at the flat backing plate and as far as I can tell its not 100% flat (curved just a tad bit) so which is the correct orientation? I'm guessing the curved side facing out (facing the crank gear) is the correct orientation. not sure how to post the pic but here is a pic below. https://imgur.com/a/APSjGXg
Follow Ups	Crank pulley backing plates Orientation - nonstopna 21:43:40 12/31/19 Re: Crank pulley backing plates Orientation - itsa300zx 23:49:56 12/31/19
Post a Followup	You cannot reply to this message because you are not logged in.