Subject	Be nice to have a spacer sleeve to put in the
Posted by	JMartz on December 09, 2019 at 4:48 PM
	This message has been viewed 235 times.
In Reply To	The new RMS isn't meant to be jammed all the way down. posted by Bernie (NoVA) on December 09, 2019 at 08:53 AM
Message	carrier first in order to control the installation depth. I did install my 1st thinner new style just below the surface of the carrier, resembling the old style OEM. I believe the leak was caused by improperly installing the pan seal. Hope to succeed this time.
Follow Ups	Rear main seal leak, as seen out the trans weep hole - JMartz 08:19:31 12/02/19 I've had an idea! - JMartz 07:45:20 12/03/19 The new RMS isn't meant to be jammed all the way down. - Bernie (NoVA) 08:53:52 12/09/19 This. I do the same. (n/m) - MixManMash 16:41:57 12/09/19 You mean remove the dowel pins or locate the seal - JMartz 16:49:12 12/09/19 The seal shouldn't be recessed in the holder. (n/m) - MixManMash 07:32:50 12/10/19 Gottit! (n/m) - JMartz 08:15:22 12/10/19 Be nice to have a spacer sleeve to put in the - JMartz 16:48:02 12/09/19 Re: I've had - JMartz 15:23:15 12/16/19
Post a Followup	You cannot reply to this message because you are not logged in.