Subject	The new RMS isn't meant to be jammed all the way down.
Posted by	Bernie (NoVA) on December 09, 2019 at 8:53 AM
	This message has been viewed 257 times.
In Reply To	I've had an idea! posted by JMartz on December 03, 2019 at 07:45 AM
Message	I install them flush to the surface. Bernie Bilski berniebilski@cox.net President of Z-Car Club of Northern Virginia 1995 Nissan 300ZX TwinTurbo in Cobalt Green 1997 Nissan 240SX SE in Ultra Red 2006 Nissan Frontier SE in Ultra Black
Follow Ups	Rear main seal leak, as seen out the trans weep hole - JMartz 08:19:31 12/02/19 I've had an idea! - JMartz 07:45:20 12/03/19 The new RMS isn't meant to be jammed all the way down. - Bernie (NoVA) 08:53:52 12/09/19 This. I do the same. (n/m) - MixManMash 16:41:57 12/09/19 You mean remove the dowel pins or locate the seal - JMartz 16:49:12 12/09/19 The seal shouldn't be recessed in the holder. (n/m) - MixManMash 07:32:50 12/10/19 Gottit! (n/m) - JMartz 08:15:22 12/10/19 Be nice to have a spacer sleeve to put in the - JMartz 16:48:02 12/09/19 Re: I've had - JMartz 15:23:15 12/16/19
Post a Followup	You cannot reply to this message because you are not logged in.