Subject	Success!
Posted by	outkaZTT on November 27, 2019 at 9:12 AM
	This message has been viewed 206 times.
In Reply To	Mounting bolts not lining up for ES Diff bushings posted by outkaZTT on November 24, 2019 at 03:18 PM
Message	I was able to finally get the bolts lined up using two C clamps to pull the diff back. I tried this a couple days ago but it required a lot of force so I was worried about damaging the diff or scratching the subframe. Thanks for the suggestions everyone.
Follow Ups	Mounting bolts not lining up for ES Diff bushings - outkaZTT 15:18:42 11/24/19 same issue for me, I used a couple ratchet straps - itsa300zx 15:47:23 11/24/19 Re: same issue for me, I used a couple ratchet straps - outkaZTT 16:00:39 11/24/19 Re: Re: same issue for me, I used a couple ratchet straps - itsa300zx 16:23:50 11/24/19 Re: Re: Re: same issue for me, I used a couple ratchet straps - outkaZTT 16:29:38 11/24/19 i would be concerned if I had to have that much pre load - Boosted1 05:41:59 11/25/19 Re: i would be concerned if I had to have that much pre load - outkaZTT 15:35:51 11/25/19 Re: Re: i would be concerned if I had to have that much pre load - pkz293 16:10:09 11/25/19 Thank you! Can you illustrate where you used them? - outkaZTT 17:56:31 11/25/19 Success! - outkaZTT 09:12:24 11/27/19
Post a Followup	You cannot reply to this message because you are not logged in.