TwinTurbo.NET: Nissan 300ZX forum - Re: Re: i would be concerned if I had to have that much pre load
Subject
Re: Re: i would be concerned if I had to have that much pre load
Posted by
pkz293
on November 25, 2019 at 4:10 PM
This message has been viewed
198
times.
In Reply To
Re: i would be concerned if I had to have that much pre load
posted by outkaZTT
on November 25, 2019 at 03:35 PM
Message
I have run into this issue on all my installs of es diff bushings (black). I hated doing it, but resorted to c-clamps in order to pull the diff back the 1/4”+ it was off. No write-ups on the internets mention this big PITA.
Follow Ups
Mounting bolts not lining up for ES Diff bushings
-
outkaZTT
15:18:42 11/24/19
same issue for me, I used a couple ratchet straps
-
itsa300zx
15:47:23 11/24/19
Re: same issue for me, I used a couple ratchet straps
-
outkaZTT
16:00:39 11/24/19
Re: Re: same issue for me, I used a couple ratchet straps
-
itsa300zx
16:23:50 11/24/19
Re: Re: Re: same issue for me, I used a couple ratchet straps
-
outkaZTT
16:29:38 11/24/19
i would be concerned if I had to have that much pre load
-
Boosted1
05:41:59 11/25/19
Re: i would be concerned if I had to have that much pre load
-
outkaZTT
15:35:51 11/25/19
Re: Re: i would be concerned if I had to have that much pre load -
pkz293
16:10:09 11/25/19
Thank you! Can you illustrate where you used them?
-
outkaZTT
17:56:31 11/25/19
Success!
-
outkaZTT
09:12:24 11/27/19
Post a
Followup
You cannot reply to this message because you are not
logged in
.