Subject	Re: Re: USDM Clock fix (revisited)
Posted by	lymon on November 12, 2019 at 10:55 PM
	This message has been viewed 282 times.
In Reply To	Re: USDM Clock fix (revisited) posted by thumper300zx on November 12, 2019 at 07:24 PM
Message	on a standard board you should measure a short (zero resistance, full continuity) between all different color sets, so zero resistance between red & red, zero resistance between blue & blue and zero resistance between yellow & yellow. If you do not measure a short between one or more of the passthrough joints/points then solder a wire in place. (or just do all, just to be safe) the wires do not bypass the resistors, they basically bypass/replace the traces on the display side of the board that have lost connection with the component side of the board.
Follow Ups	USDM Clock fix (revisited) - lymon 11:11:27 11/11/19 Thanks again, VTFAQ - itsa300zx 11:52:33 11/11/19 Re: Thanks again, VTFAQ - lymon 12:35:28 11/11/19 Additional *universal* clock fix (if nothing else worked) - lymon 02:57:51 11/12/19 Re: Additional *universal* clock fix (if nothing else worked) - thumper300zx 09:52:38 11/12/19 Re: USDM Clock fix (revisited) - thumper300zx 19:24:27 11/12/19 Re: Re: USDM Clock fix (revisited) - lymon 22:55:35 11/12/19 Re: Re: Re: USDM Clock fix (revisited) - thumper300zx 23:03:00 11/12/19 Crap... - thumper300zx 10:36:19 11/13/19 This is great, thank you very much - Polish 13:40:10 11/17/19 Brilliant! - RAD1 11:19:20 11/18/19
Post a Followup	You cannot reply to this message because you are not logged in.