TwinTurbo.NET: Nissan 300ZX forum - My 90 NA did this..
Subject
My 90 NA did this..
Posted by
Cjw3
on October 22, 2019 at 7:16 AM
This message has been viewed
286
times.
In Reply To
Heater doesn't work. Set to 90, AC is visibly operating...
posted by thumper300zx
on October 21, 2019 at 11:38 PM
Message
I had to change the Damper Actuator.. It was not moving over to the Heating Side..
Follow Ups
Heater doesn't work. Set to 90, AC is visibly operating...
-
thumper300zx
23:38:08 10/21/19
Oh, one more small detail...
-
thumper300zx
23:40:26 10/21/19
On this note, the A/C will turn off under hard acceleration
-
Agent X
06:42:23 10/22/19
Re: On this note, the A/C will turn off under hard acceleration
-
thumper300zx
18:39:13 10/22/19
Re: Re: On this note, the A/C will turn off under hard acceleration
-
thumper300zx
12:06:27 10/23/19
My 90 NA did this.. -
Cjw3
07:16:23 10/22/19
^^^ The blend motor (n/m)
-
ThisIsSparTTa
08:31:59 10/22/19
Re: My 90 NA did this..
-
thumper300zx
18:37:38 10/22/19
Re: Re: My 90 NA did this..
-
Cjw3
07:19:42 10/23/19
Jacked up the car this morning...
-
thumper300zx
10:45:07 10/23/19
The Blend Door Controls the Water Flow to the Core (n/m)
-
Cjw3
10:13:38 10/24/19
Re: The Blend Door Controls the Water Flow to the Core
-
thumper300zx
15:04:00 10/24/19
yes..BTDT (n/m)
-
Cjw3
18:39:20 10/24/19
Re: yes..BTDT
-
thumper300zx
19:56:11 10/24/19
I had some time today...
-
thumper300zx
14:54:36 10/26/19
PICS of what I did today...
-
thumper300zx
15:08:40 10/26/19
This looked hopeful, but it's for manual controls...
-
thumper300zx
16:17:39 10/26/19
Ran Diagnostics...
-
thumper300zx
21:50:57 10/22/19
Re: Ran Diagnostics...
-
mrchips
08:43:01 10/27/19
Re: Re: Ran Diagnostics...
-
thumper300zx
09:48:22 10/27/19
I'm gonna go back through diagnostics now that I know...
-
thumper300zx
12:24:00 10/27/19
Still not 100% sure I get the diagnostics...but
-
thumper300zx
23:00:06 10/27/19
Re: Still not 100% sure I get the diagnostics...but
-
thumper300zx
10:33:32 10/28/19
Post a
Followup
You cannot reply to this message because you are not
logged in
.