Subject	Re: Got her started, but still have the misfire. Needed to clean
Posted by	Metacom on September 15, 2019 at 4:51 PM
	This message has been viewed 184 times.
In Reply To	Got her started, but still have the misfire. Needed to clean posted by Woodnutz on September 15, 2019 at 02:33 AM
Message	You mentioned in that other post you have some spliced in coil pack connectors? A continuity check will test OK even if a single strand of wire is hanging on though in an energized circuit that single strand instead of a thicker complete wire would be a large voltage drop.
Follow Ups	Ignition head-scratcher. From misfire to no fire... - Woodnutz 01:18:54 09/14/19 Go back to the 4 ptu connections and double check they are - itsa300zx 13:43:03 09/14/19 Got her started, but still have the misfire. Needed to clean - Woodnutz 02:33:19 09/15/19 Re: Got her started, but still have the misfire. Needed to clean - Metacom 16:51:25 09/15/19 I had suspected spliced replacement connectors with pigtails - Woodnutz 06:16:45 09/16/19 I'd get rid of that sub harness completely (n/m) - itsa300zx 11:12:51 09/16/19 Well, got contacts clean and verified continuity between the - Woodnutz 05:11:47 09/20/19
Post a Followup	You cannot reply to this message because you are not logged in.