TwinTurbo.NET: Nissan 300ZX forum - Got her started, but still have the misfire. Needed to clean
People Seeking Info
 
   


     
Subject Got her started, but still have the misfire. Needed to clean
     
Posted by Woodnutz on September 15, 2019 at 2:33 AM
  This message has been viewed 188 times.
     
In Reply To Ignition head-scratcher. From misfire to no fire... posted by Woodnutz on September 14, 2019 at 01:18 AM
     
Message up the contacts between the coil branch/series 2 jumper harness (7-pin wire retainer type). Didn't have ground. No fire on #4 continues to be a mystery. Coil packs ohms out at .7-.8 and has continuity back to the PTU. Still scratching my head, but at least I got her to start. I'll swap coil packs just to verify that's not the culprit maybe later Sunday.

I've yet to check connections further upstream. I have a feeling that'll be fun. Again, any tips from your experience is much appreciated (thanks Peter!).

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.