Subject	Trying to stab transmission. Almost there...help, please!
Posted by	Woodnutz on August 24, 2019 at 9:34 AM
	This message has been viewed 247 times.
Message	1st time doing this... I have it on the jack. Feels like the shaft has started into the pilot bushing (flywheel teeth are just about completely concealed by the bell housing), but it just won`t go home. I was able to get one of the short bell housing bolts to start, hoping to walk it in a bit on each side, but it locked it into place pretty firmly (not close enough to thread the other short bolf on the other side). Any tips are much appreciated. FYI, I am going off the clutch writeup via th tech page. Thanks!
Follow Ups	Trying to stab transmission. Almost there...help, please! - Woodnutz 09:34:42 08/24/19 Re: Trying to stab transmission. Almost there...help, please! - Cjw3 10:02:10 08/24/19 Got it! Needed more wiggle and jiggle. Thanks for the tip! (n/m) - Woodnutz 10:46:00 08/24/19 Re: Trying to stab transmission. Almost there...help, please! - sparkie 11:30:07 08/26/19 Did you label where each bolt went? - FrozTTy 15:11:54 08/27/19 Nah, the FSM and Damon’s guide have them called out. - Woodnutz 00:20:30 08/28/19 Re: Trying to stab transmission. Almost there...help, please! - SammybTT(TN) 18:49:16 08/29/19
Post a Followup	You cannot reply to this message because you are not logged in.