Subject	Re: Doing valve covers, couple of questions>>>
Posted by	CarolinaZ_TT on July 15, 2019 at 1:25 PM
	This message has been viewed 280 times.
In Reply To	Doing valve covers, couple of questions>>> posted by Woodnutz on July 15, 2019 at 01:07 PM
Message	Photo from question #1 won't load on my work computer but I'll answer #2. If you're planning to keep the PCV system in place, you can re-seat that elbow in place using RTV as you suggested. I did this the first time I addressed my valve cover gaskets with no oil leaks/issues. If you are planning to delete the PCV system, you can drill and tap that hole where the elbow(s) was/are. There are write ups showing this process. Or, you can use freeze plugs with some RTV if you prefer not to drill...Specialty Z sells a "kit" found here La-Z-Link . I currently have the freeze plugs in place and have deleted my PCV system all together running vent to atmosphere on the intake covers. Everyone here has their own 2 cents on the topic. Personally, I think the drilled and tapped method produces a "cleaner" look but a freeze plug will serve the same purpose.
Follow Ups	Doing valve covers, couple of questions>>> - Woodnutz 13:07:57 07/15/19 Re: Doing valve covers, couple of questions>>> - CarolinaZ_TT 13:25:21 07/15/19 I'm leaning toward deleting PCV just as you have. After - Woodnutz 05:32:04 07/16/19 For #1 - I don’t recall doing anything special to get - jzack 22:11:31 07/15/19 Thanks, John - I did disconnect them prior to trying to - Woodnutz 05:37:37 07/16/19
Post a Followup	You cannot reply to this message because you are not logged in.