Subject	Re: Exhaust Shop wants to lift the Z by the pinch welds?
Posted by	itsa300zx on June 03, 2019 at 12:49 PM
	This message has been viewed 371 times.
In Reply To	Exhaust Shop wants to lift the Z by the pinch welds? posted by dls322 on June 03, 2019 at 10:48 AM
Message	I don't see a problem here. The rears points can be place at the jack stand position just in front of the tires.
Follow Ups	Exhaust Shop wants to lift the Z by the pinch welds? - dls322 10:48:51 06/03/19 Re: Exhaust Shop wants to lift the Z by the pinch welds? - itsa300zx 12:49:02 06/03/19 I do it all the time using hard rubber blocks. No problems. - Gordo NA2LS Daytona 19:34:06 06/03/19 Blocks are 4x8x3 so load is spread along 8" of pinch weld. (n/m) - Gordo NA2LS Daytona 19:54:35 06/03/19 Where did you find the blocks? (n/m) - ctheobal 13:43:55 06/06/19 eBay - Rubber Lift Blocks... 4 each for $70 (n/m) - Gordo NA2LS Daytona 16:40:41 06/06/19 Awesome! Thank you Sir! BTW your car is Bitchin! (n/m) - ctheobal 14:36:44 06/07/19 Show off!!! (n/m) - FrozTTy 09:00:16 06/06/19 Re: Exhaust Shop wants to lift the Z by the pinch welds? - Metacom 20:51:38 06/03/19
Post a Followup	You cannot reply to this message because you are not logged in.