Subject	Help: Cylinder head bolt stripped
Posted by	valleyz32 on May 15, 2019 at 7:36 PM
	This message has been viewed 305 times.
Message	hello everyone! Im replacing both my head gaskets on my 1990 tt and everything was going good until i had to place back my passenger side cylinder head and the short head bolt stripped the block on me. (yes i was torquing correcting, what i believe was i didn't air out that thread hole very well). any recommendations on helicoil or time sert kits for re threading that hole on the block? I do know the head bolts are M12x1.75 I believe but any suggestions or advice would be great! thank you.
Follow Ups	Help: Cylinder head bolt stripped - valleyz32 19:36:40 05/15/19 Look for a Keensert - -Grimm- 15:05:27 05/20/19
Post a Followup	You cannot reply to this message because you are not logged in.