Subject	I was using a Specialty Z chip with dual pop and set up for
Posted by	BannonZ on May 15, 2019 at 9:46 AM
	This message has been viewed 264 times.
In Reply To	Is your chip setup for dual or single pop? posted by MLPS300ZX on May 14, 2019 at 04:50 PM
Message	the 615 yellow tops, the car never ran the 615's with my Z1 chip that was set for single and 555 purple tops. To compensate thinking the fuel map was too rich, Bernie loaned me this JWT chip which is actually tuned for a milder 608 cc set up and dual pop. I have had the selin on AVG mode for both, and not add. When I first got my specialty Z chip I got this message: "Not a problem, your order is completed and the USPS tracking is: 9405503699300418990411 Please make sure and set your Selin Translator to AVG. Thanks for your order!!"" So I had done that since day one. Just for haha's I just checked and it's on avg mode.
Follow Ups	Starting issue: Continued - BannonZ 09:58:50 05/11/19 More parts replaced - BannonZ 10:23:36 05/11/19 Fuel pump controller unit? - FrozTTy 11:02:40 05/11/19 hmm - BannonZ 11:32:09 05/11/19 Did you bypass the FPCM? (n/m) - FrozTTy 09:35:28 05/14/19 Not yet. (n/m) - BannonZ 11:45:22 05/15/19 Re: Fuel pump controller unit? - Metacom 16:07:09 05/11/19 Yes - BannonZ 19:24:48 05/11/19 Check this thread out - Cjw3 11:39:57 05/11/19 Definitely has similarities. It hasn't been more than 50 f - BannonZ 13:12:55 05/11/19 Re: Definitely has similarities. It hasn't been more than 50 f - Cjw3 14:07:42 05/11/19 Re: Starting issue: Continued - MLPS300ZX 21:29:07 05/12/19 Re: Re: Starting issue: Continued - MLPS300ZX 21:34:28 05/12/19 Where is this valve located? (n/m) - FrozTTy 08:31:18 05/13/19 This one? - BannonZ 11:49:27 05/13/19 Yes that, but I'm wondering where it is on the car... (n/m) - FrozTTy 15:37:09 05/13/19 That's it. It's on TTs only. I have a fuel pressure gauge... - MLPS300ZX 14:45:40 05/13/19 I did a fuel pressure test today. - BannonZ 14:57:57 05/13/19 Is your chip setup for dual or single pop? - MLPS300ZX 16:50:31 05/14/19 I also brought this up (below) - FrozTTy 17:02:25 05/14/19 I was using a Specialty Z chip with dual pop and set up for - BannonZ 09:46:37 05/15/19 50psi cranking seems high. - MLPS300ZX 22:55:49 05/20/19 To back up a little for diagnostic purposes: When did the - SirpriZ 15:33:12 05/13/19 I have had this problem, getting progressively worse since - BannonZ 07:52:20 05/14/19 You've ruled out alot of potential issues: It isn't the - SirpriZ 18:35:43 05/14/19 Thank you for your help. - BannonZ 09:37:07 05/15/19 YW I don't think an internal engine issue would cause all - SirpriZ 15:09:32 05/15/19 What about the wiring that relocated PTU? - FrozTTy 09:34:04 05/14/19 When I put the new PTU in I replaced the harness with a - BannonZ 09:39:32 05/15/19 Silly question, but are you sure the gas is good? (n/m) - ZBOOSTT 14:13:38 05/15/19 I don't keep more than a quarter tank in the vehicle - BannonZ 14:44:09 05/15/19 Try one gallon of Toluene and that will clean the injectors - ZBOOSTT 18:59:51 05/20/19 Update - BannonZ 15:59:22 05/21/19 That's a shame. At least you'll have a definitive idea of - SirpriZ 19:46:17 05/21/19 That's a bummer! Keep us posted! (n/m) - MLPS300ZX 02:54:25 05/22/19 Thanks guys, I will let you know. - BannonZ 07:26:51 05/22/19 GL let us know what's next (n/m) - FrozTTy 08:19:25 05/23/19
Post a Followup	You cannot reply to this message because you are not logged in.