Subject	Re: Could have droped its learned values if it was all dead
Posted by	chinaoreo on May 01, 2019 at 9:35 AM
	This message has been viewed 246 times.
In Reply To	Could have droped its learned values if it was all dead (n/m) posted by kickerzx on April 30, 2019 at 02:36 PM
Message	update.:: problem still exist. i have found that upon cold start engine is a tad rough for a minute or 2 then it smooths out. also blipping the throttle there is a very slight stumble before rpms pick up. strangely enough unplugging the grey TPS plug helps both of these considerably. throttle response when blipping is crisp and immediate like it should be. the idle is still dipping down to about 500 then leveling off after revving though..do u think my tps is going bad..?
Follow Ups	idle falls after rev - chinaoreo 10:27:46 04/29/19 Did you by any chance calibrate/adjust your throttleblades - kickerzx 13:23:28 04/30/19 Re: Did you by any chance calibrate/adjust your throttleblades - chinaoreo 09:24:10 05/01/19 Re: idle falls after rev - Metacom 14:29:38 04/30/19 Could have droped its learned values if it was all dead (n/m) - kickerzx 14:36:06 04/30/19 Re: Could have droped its learned values if it was all dead - chinaoreo 09:25:52 05/01/19 Re: Could have droped its learned values if it was all dead - chinaoreo 09:35:12 05/01/19 Re: Re: idle falls after rev - chinaoreo 09:24:04 05/02/19 Re: Re: idle falls after rev - chinaoreo 14:21:35 05/03/19 Re: Re: Re: idle falls after rev - Metacom 21:11:35 05/03/19
Post a Followup	You cannot reply to this message because you are not logged in.