Subject	idle falls after rev
Posted by	chinaoreo on April 29, 2019 at 10:27 AM
	This message has been viewed 251 times.
Message	ok so i know this dead horse has been beat over and over again and ive scoured the web but still cant find a fix. so im reaching out to the z32 community..here goes.. i just rebuilt the motor and everything was fine until my batt went dead..hooked charger up and started and now my idle is falling/stumbling after revving the engine. its drops down to 200 or so rpm then bounces right back up..it might yoyo a couple times before it settles at normal idle again. other than that theres in no problems or driveability issues things i have already done or know: code 55 NO vaccuum leaks or boost leaks all conectors and plugs are squeaky clean with electrical grease aac/iacv is clean and working fine tps is set to 4.4 and working/tested fine. hard idle is working fine timing is on 15* compression is good..fresh rebuild hittin on all 6 egr..aiv..prvr all deleted no blow off valves. recirc valves are working fine injectors are freshly cleaned and fine mafs are working fine.. silen dual setup im now at a loss and any help would be greatly appreciated..thanks..!
Follow Ups	idle falls after rev - chinaoreo 10:27:46 04/29/19 Did you by any chance calibrate/adjust your throttleblades - kickerzx 13:23:28 04/30/19 Re: Did you by any chance calibrate/adjust your throttleblades - chinaoreo 09:24:10 05/01/19 Re: idle falls after rev - Metacom 14:29:38 04/30/19 Could have droped its learned values if it was all dead (n/m) - kickerzx 14:36:06 04/30/19 Re: Could have droped its learned values if it was all dead - chinaoreo 09:25:52 05/01/19 Re: Could have droped its learned values if it was all dead - chinaoreo 09:35:12 05/01/19 Re: Re: idle falls after rev - chinaoreo 09:24:04 05/02/19 Re: Re: idle falls after rev - chinaoreo 14:21:35 05/03/19 Re: Re: Re: idle falls after rev - Metacom 21:11:35 05/03/19
Post a Followup	You cannot reply to this message because you are not logged in.