Subject	M10x1.0mm (n/m)
Posted by	itsa300zx on January 12, 2019 at 12:47 PM
	This message has been viewed 217 times.
In Reply To	I pretty sure none of the clutch lines are tapered pipe posted by itsa300zx on January 10, 2019 at 10:03 PM
Message
Follow Ups	clutch master cylinder thread pitch? - RZturbo 16:18:51 01/10/19 I pretty sure none of the clutch lines are tapered pipe - itsa300zx 22:03:28 01/10/19 M10x1.0mm (n/m) - itsa300zx 12:47:15 01/12/19
Post a Followup	You cannot reply to this message because you are not logged in.