TwinTurbo.NET: Nissan 300ZX forum - Re: Badly leaking injector or injector o-ring would be
Subject
Re: Badly leaking injector or injector o-ring would be
Posted by
ChezZ
on January 10, 2019 at 7:59 PM
This message has been viewed
292
times.
In Reply To
Badly leaking injector or injector o-ring would be
posted by jzack
on January 10, 2019 at 06:26 PM
Message
how do I know if there is gasoline all over my vacuum system? I'm thinking of uv dye but will it still be safe to drive under the circumstance(engine hydrolock)? Could it just be a stuck-open pcv valve?
Follow Ups
Leaking fuel from pcv hose
-
ChezZ
18:17:25 01/10/19
Badly leaking injector or injector o-ring would be
-
jzack
18:26:14 01/10/19
Re: Badly leaking injector or injector o-ring would be -
ChezZ
19:59:56 01/10/19
Actually that’s a good suggestion about a bad r
-
jzack
22:23:19 01/10/19
Re: Actually that’s a good suggestion about a bad r
-
ChezZ
22:35:36 01/10/19
I'm going to point out the obvious
-
CarolinaZ_TT
07:52:06 01/11/19
Re: I'm going to point out the obvious
-
ChezZ
00:02:56 01/12/19
Re: Leaking fuel from pcv hose
-
njz
20:22:59 01/10/19
I still thinks it’s the fuel regulator or damper...
-
itsa300zx
21:10:01 01/10/19
Re: I still thinks it’s the fuel regulator or damper...
-
ChezZ
22:32:54 01/10/19
I was thinking apply vacuum with a manual pump
-
itsa300zx
22:51:35 01/10/19
Re: I was thinking apply vacuum with a manual pump
-
ChezZ
22:56:22 01/10/19
Yes, that’s what I would try. Just be ready to shut
-
itsa300zx
23:05:12 01/10/19
Re: Yes, that’s what I would try. Just be ready to shut
-
ChezZ
23:16:09 01/10/19
Probably best to do both of them...also I think the
-
jzack
23:25:14 01/10/19
Post a
Followup
You cannot reply to this message because you are not
logged in
.