Subject	97-01 Q45 R200 diff is a bolt in
Posted by	Barry(TN) on December 28, 2018 at 10:06 AM
	This message has been viewed 311 times.
In Reply To	Swapping Ring Gear Advice posted by Keaner on December 28, 2018 at 07:12 AM
Message	Ratio is same as TT at 3.69. Swap the flange on the pinion and you are good to go.
Follow Ups	Swapping Ring Gear Advice - Keaner 07:12:25 12/28/18 97-01 Q45 R200 diff is a bolt in - Barry(TN) 10:06:44 12/28/18 Re: 97-01 Q45 R200 diff is a bolt in - Keaner 10:10:55 12/28/18 any idea if the q45 G50 r200v fits too? has the 3.53 (n/m) - Keaner 12:18:19 12/28/18 Earlier Q45 (96 & older) had 6 bolt output flanges - Barry(TN) 11:43:39 12/29/18 Shucks! alright, thanks! - Keaner 14:46:33 12/29/18 Is your dissatisfaction with the R200 due to the shortness - SirpriZ 15:29:33 12/30/18 Traction caused by shortness- - Keaner 10:15:54 12/31/18 Be sure to change the speed sensor. (n/m) - MixManMash 18:27:07 12/31/18 :) Already done, never swapped to NA after my TT swap. (n/m) - Keaner 20:12:57 12/31/18
Post a Followup	You cannot reply to this message because you are not logged in.