Subject	It's actually 1/8" JISPT ........
Posted by	zx299 on December 23, 2018 at 3:49 PM
	This message has been viewed 260 times.
In Reply To	thanks...is it really 1/8" BSPT ? posted by TTkeeper on December 22, 2018 at 06:44 PM
Message	which is a Japanese pipe thread. It is interchangeable with BSPT but I always use thread tape to ensure a good seal (makes it easier to undo as well) . . . . "If you own a 300zx, you don't have time for a hobby" "If you own more than one 300zx, you don't have time for a life"
Follow Ups	Oil sending unit...thread direction? - TTkeeper 15:16:10 12/22/18 Turn it counterclockwise (n/m) - itsa300zx 15:59:17 12/22/18 thanks...is it really 1/8" BSPT ? - TTkeeper 18:44:51 12/22/18 Yes (n/m) - itsa300zx 19:57:29 12/22/18 Yes to clearance issues ? - TTkeeper 14:51:58 12/27/18 Yep, it is. Put some silicone around the threads and try to - Tanley (ATL) 19:59:12 12/22/18 Any clearance issues with larger aftermarket turbos? - TTkeeper 09:00:04 12/23/18 I keep a handful of 45 degree fittings on hand. (n/m) - Woody75 (Denver) 09:42:16 01/02/19 It's actually 1/8" JISPT ........ - zx299 15:49:38 12/23/18 and I believe its tapered...not parallel (n/m) - TTkeeper 13:51:21 12/24/18 PT signifies "Pipe Tapered" ......... - zx299 15:36:04 12/24/18 fraction of a mm...that's cutting it fine - TTkeeper 19:53:46 12/26/18 PTFE tape (Polytetrafluoroethylene) is usually white ...... - zx299 15:00:29 12/27/18
Post a Followup	You cannot reply to this message because you are not logged in.