Subject	Per EM-29, the combination of the block and the heads being
Posted by	MixManMash on December 21, 2018 at 1:12 PM
	This message has been viewed 297 times.
In Reply To	Cylinder Head Decking Info posted by Adam393 on December 20, 2018 at 09:38 PM
Message	resurfaced is 0.2mm. Mine were milled down a fair bit more than that and I used stock head gaskets. Of course, this can throw cam timing out a bit, but I have adjustable cam gears. EM-63 shows how you take the measurement. I hope that helps.
Follow Ups	Cylinder Head Decking Info - Adam393 21:38:46 12/20/18 Per EM-29, the combination of the block and the heads being - MixManMash 13:12:48 12/21/18
Post a Followup	You cannot reply to this message because you are not logged in.