Subject	Don't regret. You can still buy them. But you'll only
Posted by	MixManMash on December 21, 2018 at 7:17 AM
	This message has been viewed 254 times.
In Reply To	Re: Per MagicMike, the only thing I can think is posted by outkaZTT on December 20, 2018 at 08:18 PM
Message	benefit from custom tuning. That will make the biggest difference. I have found with the JWT 400, 400+, 500, you sacrifice a lot of bottom end torque without the gears. Add the gears, get them dialed in and it's a big difference. Here's a good before and after on the 400+.
Follow Ups	Help diagnosing A/F ratio differential between passenger - SirpriZ 18:10:00 12/18/18 Re: Help diagnosing A/F ratio differential between passenger - MagicMike 18:54:56 12/18/18 This. I see a difference, especially at idle between the - MixManMash 21:50:11 12/18/18 Do you see differences between the banks under different - SirpriZ 12:40:27 12/19/18 Mostly under idle, light/cruising loads. - MixManMash 19:04:20 12/19/18 Thanks. With Haltech you can adjust A/F ratios from - SirpriZ 19:48:30 12/19/18 Per MagicMike, the only thing I can think is - MixManMash 13:56:30 12/20/18 Re: Per MagicMike, the only thing I can think is - outkaZTT 20:18:30 12/20/18 Don't regret. You can still buy them. But you'll only - MixManMash 07:17:58 12/21/18 I should mention this is vorpalZed (vorpalZ formally) - MixManMash 10:13:04 12/21/18 Re: Don't regret. You can still buy them. But you'll only - outkaZTT 17:46:33 12/21/18 Thanks for the reply! - outkaZTT 09:54:12 12/19/18 Talk to SZ, but I'm very sure they run serial setups on high - MixManMash 19:06:17 12/19/18 Re: Talk to SZ, but I'm very sure they run serial setups on high - outkaZTT 19:31:44 12/19/18 typically at idle / low speed it usually is a function of a - The Devils Z 09:19:48 12/29/18 Thanks for the reply as well. You stated you have certain - SirpriZ 12:44:51 12/19/18 Re: Thanks for the reply as well. You stated you have certain - MagicMike 17:39:03 12/19/18 I am wondering if a difference in cam timing from bank to - SirpriZ 19:12:09 12/19/18 Re: I am wondering if a difference in cam timing from bank to - MagicMike 20:03:24 12/19/18
Post a Followup	You cannot reply to this message because you are not logged in.