Subject	JWT 500 Cams with Ferrea springs???
Posted by	backinblack626 on November 28, 2018 at 3:11 PM
	This message has been viewed 265 times.
Message	Ive just purchased some JWT 500 hydraulic cams as well as a full Ferrea valve kit for my current build. So it seems the heigh is 35 mm on both Ferrea and JWT springs. Ferrea springs have 80lbs spring pressure and JWT has 71. JWT has been extremely vocal about using only their valve springs. A source from CZP claims they will be just fine. Has anyone used Ferrea springs with JWT cams? Also does anyone know if the valves are same height at stock? Above two specs are only two I could find. Full compressed height is also important. Any insight is greatly appreciated.
Follow Ups	JWT 500 Cams with Ferrea springs??? - backinblack626 15:11:02 11/28/18 I personally would recommend going with the JWT springs. - MixManMash 15:31:55 11/28/18
Post a Followup	You cannot reply to this message because you are not logged in.