TwinTurbo.NET: Nissan 300ZX forum - Install both and see which one fits best. Or make your own.
People Seeking Info
 
   


     
Subject Install both and see which one fits best. Or make your own.
     
Posted by Gordo NA2LS Daytona on November 02, 2018 at 3:01 PM
  This message has been viewed 82 times.
     
In Reply To Bush league clutch slave cylinder question. I'm replacing posted by 240Z FeO2 on November 01, 2018 at 08:44 PM
     
Message You're looking for a fit that touches, but does not depress the throwout bearing. I made an 'adjustable' piston rod by using a long shouldered bolt and acorn nut on the end w/ stop nut.

_________________________________________________


     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.