TwinTurbo.NET: Nissan 300ZX forum - FUCA install help needed. Top Speed arm (driver side).
People Seeking Info
 
   


     
Subject FUCA install help needed. Top Speed arm (driver side).
     
Posted by msb1987 on October 16, 2018 at 10:49 PM
  This message has been viewed 360 times.
     
     
Message After putting the arm and plate back onto the wheel well I can't get the inside (left) part of the arm and the upright to line up. I can get the right side of the arm to line up. Are these like the Z1 FUCA's that have one side slightly narrower than the other? I thought I had read that the offset orientation doesn't matter. Does it? I did see the FAQ but it didn't help with my problem. Thanks in advance.

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.