Subject	From what I can see in your video
Posted by	CarolinaZ_TT on September 26, 2018 at 12:18 PM
	This message has been viewed 295 times.
In Reply To	I have everything back together other than a few connectors. posted by Mightget300zx on September 26, 2018 at 11:21 AM
Message	Those two wires connectors that wouldn't reach should connect to the throttle sensor and hard idle switch. Maybe check the harness for alternative routing methods as they should reach and you're not going far without them plugged in. The last connector you eluded to is either the knock sensor, VTC, or O2 sensor. A new knock sensor and subharness are easy to source and can be mounted using the far back upper to lower plenum bolt as a temp solution.
Follow Ups	Do I even need to upgrade injectors and ECU? - Mightget300zx 18:03:09 09/23/18 Re: Do I even need to upgrade injectors and ECU? - Bigmatthew86 19:04:50 09/23/18 the stock turbos are good for up to 20lbs, 22lbs on e85 - Boostjuice 10:10:54 09/24/18 Re: the stock turbos are good for up to 20lbs, 22lbs on e85 - Mightget300zx 17:58:45 09/24/18 Re: Re: the stock turbos are good for up to 20lbs, 22lbs on e85 - Bigmatthew86 09:49:26 09/25/18 Also go to the 7's for spark plugs (n/m) - Boostjuice 10:13:00 09/24/18 I have everything back together other than a few connectors. - Mightget300zx 11:21:37 09/26/18 From what I can see in your video - CarolinaZ_TT 12:18:54 09/26/18 Re: From what I can see in your video - Mightget300zx 14:36:30 09/26/18 Re: Re: From what I can see in your video - Mightget300zx 09:00:54 09/27/18 Re: I have everything back together other than a few connectors. - Mightget300zx 19:42:21 09/27/18 Nice - a roll of masking tape and a sharpie next time ;) (n/m) - CarolinaZ_TT 07:42:02 09/28/18
Post a Followup	You cannot reply to this message because you are not logged in.