Subject	Excellent info. Did you unbolt the hoses before or after
Posted by	ZXoltan on August 09, 2018 at 4:54 PM
	This message has been viewed 265 times.
In Reply To	Wanted to followup on my success with the crowfoot. posted by 240Z FeO2 on August 09, 2018 at 04:17 PM
Message	dropping the compressor? (and I assume opposite goes for re-install?)
Follow Ups	My AC compressor needs to be replaced. I'm thinking - 240Z FeO2 10:43:53 08/03/18 My experience from replacing - Barry(TN) 14:12:27 08/03/18 When I did mine, needed to use a Dremel conical shaped - jzack 18:09:09 08/03/18 Re: My AC compressor needs to be replaced. I'm thinking - Zxpress 13:24:09 08/04/18 Remove the rear bolt first - Woody75 (Denver) 09:01:15 08/06/18 What are you going to be replacing it with? - ZXoltan 10:25:23 08/06/18 Pricey, but just planning on going with OEM. (n/m) - 240Z FeO2 10:37:51 08/06/18 Air Parts in Ocala, FL or eBay - SkiFly01 15:07:22 08/08/18 What did they replace? Just front seal or more? - ZXoltan 07:27:18 08/09/18 It was a seal kit for the case, front half and back half. - SkiFly01 09:54:52 08/09/18 Also, I went back with 2 more cores and swapped out. - SkiFly01 10:17:25 08/09/18 Wanted to followup on my success with the crowfoot. - 240Z FeO2 16:17:01 08/09/18 Excellent info. Did you unbolt the hoses before or after - ZXoltan 16:54:14 08/09/18 Before. With the nuts off I could barely raise the hoses - 240Z FeO2 17:55:15 08/10/18 I've always used the style on the right. Works for me. (n/m) - Woody75 (Denver) 09:05:23 08/10/18 Interesting. I tried two of the smaller variety of CF. - 240Z FeO2 11:53:25 08/10/18
Post a Followup	You cannot reply to this message because you are not logged in.