TwinTurbo.NET: Nissan 300ZX forum - To properly test starter it needs to be under load and >>
Subject
To properly test starter it needs to be under load and >>
Posted by
ZUL8TR
on August 01, 2018 at 6:59 AM
This message has been viewed
258
times.
In Reply To
I've replaced everything I can think of.
posted by aquariuscsm
on August 01, 2018 at 06:44 AM
Message
that is generally not done at the bench. I went thru a few starters that checked OK at the bench but were faulty. Either bad solenoid or starter armature.
ZUL8TR
Follow Ups
Damn car STILL won't start!
-
aquariuscsm
19:21:17 07/30/18
Is the Engine Locked up? (n/m)
-
Cjw3
19:46:24 07/30/18
Nope,it push starts perfectly.
-
aquariuscsm
20:18:00 07/30/18
Then the 'Big Starter Lead' has to be broken from the Batt (n/m)
-
Cjw3
20:52:08 07/30/18
What exactly would I be looking for?
-
aquariuscsm
20:59:27 07/30/18
Verify visually that the starters +12v power cable looks
-
jzack
09:49:09 08/01/18
The solenoid clicks loud and strong
-
aquariuscsm
18:21:26 07/31/18
Check the starter relay. Relays can have continuity>>
-
ZUL8TR
03:12:01 08/01/18
I've replaced everything I can think of.
-
aquariuscsm
06:44:39 08/01/18
To properly test starter it needs to be under load and >> -
ZUL8TR
06:59:13 08/01/18
Re: Damn car STILL won't start!
-
Adam393
07:50:12 08/01/18
Re: Damn car STILL won't start!
-
rhombicblue
10:55:58 08/02/18
Did you read my reply below?
-
FrozTTy
08:06:34 08/04/18
Post a
Followup
You cannot reply to this message because you are not
logged in
.