Subject	Well, any work I perform is always thought-out
Posted by	FrozTTy on July 25, 2018 at 7:11 AM
	This message has been viewed 242 times.
In Reply To	Z32 wiring corrosion is nothing compared to posted by Doug71zt(CAN) on July 25, 2018 at 02:10 AM
Message	and well planned ahead of time. My Z is my DD, which is the main reason it's never been off the road for a motor pull. I should have done it years ago myself instead of having someone drop in the JDM combo I purchased. I think my Z would run close to perfect with a new EFI harness. Any specific kind of wire to install, if cutting out old corroded wire like MixManMash suggested? He didn't answer this question below. Thanks Doug71!
Follow Ups	Another Intermittent Hesitation Post.... - FrozTTy 08:14:43 07/22/18 Did you clear that code yet? (n/m) - compirate 09:57:39 07/22/18 No I have never pulled the motor (n/m) - FrozTTy 10:43:26 07/22/18 I meant from the ECU. (n/m) - compirate 15:03:35 07/22/18 i dont have any datascan etc - FrozTTy 19:11:30 07/22/18 Check the coolant temp sensor plug/wiring first - Doug71zt(CAN) 17:46:21 07/22/18 Solid insight...thanks I will look around (n/m) - FrozTTy 19:10:01 07/22/18 My PTU is direct wired - no more subharness - FrozTTy 09:04:29 07/23/18 Z32 wiring corrosion is nothing compared to - Doug71zt(CAN) 02:10:20 07/25/18 Well, any work I perform is always thought-out - FrozTTy 07:11:30 07/25/18 Yes, tough to do if its a DD - Doug71zt(CAN) 08:09:25 07/25/18 I was also curious about the coil packs. - FrozTTy 09:06:00 07/23/18 This. Even check up the harness at length from connectors. - MixManMash 14:28:11 07/23/18 Would electrical contact cleaner help with this type of - FrozTTy 07:19:03 07/24/18 Electrical contact cleaner is not going to get under the - MixManMash 07:32:01 07/24/18 Well duh. I meant for actual cleaning. - FrozTTy 10:52:41 07/24/18 Is there a certain 'kind' of wire that must be used? (n/m) - FrozTTy 13:54:24 07/24/18 Not really. I used CSA type TEW which is UL type MTW. (n/m) - MixManMash 07:43:37 07/25/18
Post a Followup	You cannot reply to this message because you are not logged in.