Subject	I think if your controller is still stock and hasn't been
Posted by	not4resaleZ on June 26, 2018 at 6:05 PM
	This message has been viewed 270 times.
In Reply To	Single walbro pump will burn out the controller. Yes or No? posted by MeatMan (604Z) on June 25, 2018 at 11:43 PM
Message	worked on, it is likely to burn out. Mine burned up and I expected it just due to it's age, but it left me stranded. Stock pump or walbro, but walbro may speed it up a bit. They seem to all be near the end of life for the capacitors. You might contact DVDBURN (MD) to have it refreshed, or beefed up.
Follow Ups	Question for you guys who have converted to E85 - MeatMan (604Z) 00:21:46 06/24/18 Re: Question for you guys who have converted to E85 - rhombicblue 08:35:03 06/24/18 I installed a single walbro 485 pump (n/m) - MeatMan (604Z) 13:15:31 06/24/18 Mines at 42 with vacuum disconnected then goes down to 32 - Boostjuice 16:09:27 06/24/18 You may have too much flow for your FPR to bypass. - not4resaleZ 10:12:52 06/25/18 you have to bypass the controlller anyway when - Boostjuice 12:44:03 06/25/18 I'm running the Ashspec dual pump controller with a - not4resaleZ 15:43:33 06/25/18 I am thinking this is the issue too. I hate aftermarket reg. (n/m) - MeatMan (604Z) 12:46:01 06/25/18 Use an adjustable fuel pressure regulator. - puchy 10:40:21 06/25/18 I was instructed to Bypass the controller by SZ. (n/m) - MeatMan (604Z) 12:44:04 06/25/18 I wonder why, maybe because you don’t have an AFPR? - puchy 22:23:59 06/25/18 This is my FP fully warmed up at idle - MeatMan (604Z) 22:53:27 06/25/18 Single walbro pump will burn out the controller. Yes or No? - MeatMan (604Z) 23:43:12 06/25/18 I think if your controller is still stock and hasn't been - not4resaleZ 18:05:02 06/26/18
Post a Followup	You cannot reply to this message because you are not logged in.