Subject	Detonation sensor wiring... is this right?
Posted by	GrecV2 on June 25, 2018 at 7:40 PM
	This message has been viewed 368 times.
Message	So... I'm throwing a code 34. Start poking around the connector and I realize that it's got a ton of electrical tape on the end with the male connector, (to the sensor, yes?) seemingly from a previous repair. So I undo it all, and see this: link to pic Also, I did a meter test on the female side and I got a .560 (when set to 2MM) and .000 on the other. That sound about right? Former Stage V addict... off the wagon.
Follow Ups	Detonation sensor wiring... is this right? - GrecV2 19:40:28 06/25/18 That is how it's wired from the factory - FrozTTy 08:19:20 06/26/18 Huh. Surprising to hear. So now a question on bypassing... - GrecV2 08:55:18 06/26/18 BTW, I was unable to get a reading off sensor harness - GrecV2 09:11:01 06/26/18 You don't even have to solder it in. Just put the leads of - MixManMash 19:37:34 06/26/18 Copy that. Thanks, bud. (n/m) - GrecV2 21:34:39 06/26/18
Post a Followup	You cannot reply to this message because you are not logged in.