Subject	Same problem. Same Greddy Profec. I was boosting
Posted by	ZTicket(Dallas) on June 21, 2018 at 9:56 AM
	This message has been viewed 254 times.
In Reply To	Wastegate stuck closed? posted by Schmeal (NV) on June 19, 2018 at 10:17 AM
Message	past my target setup. Thought the Greddy was the problem. Unhooked the vac lines to be safe and thought that I would only boost the wastegate setting(7psi). Shocked to find that I was still boosting 15-17psi under wide open throttle. I'm thinking the internal wastegates on my stockers are "frozen shut/rusted". I would test this theory out, if I could access the wastegate actuators. But, I can't find a way to get in there without removing a lot of stuff. I stay out of max boost until I can figure this out.
Follow Ups	Wastegate stuck closed? - Schmeal (NV) 10:17:32 06/19/18 Which EBC are you using? (n/m) - MixManMash 21:19:10 06/19/18 Greddy Profec (n/m) - Schmeal (NV) 21:35:51 06/19/18 Double check the connections on the solenoid as there are 3 - MixManMash 17:58:10 06/20/18 The solenoid isn't currently connected. - Schmeal (NV) 18:25:38 06/20/18 Is there a leak in the vacuum line that tells the solinoid - Barry (NJ) 08:59:37 06/20/18 I'm going to check this out. - Schmeal (NV) 10:01:18 06/20/18 Same problem. Same Greddy Profec. I was boosting - ZTicket(Dallas) 09:56:37 06/21/18 That is a bummer. - Schmeal (NV) 11:51:50 06/21/18
Post a Followup	You cannot reply to this message because you are not logged in.