Subject	For any location where the direction of the gasket goes
Posted by	jzack on June 14, 2018 at 11:34 PM
	This message has been viewed 257 times.
In Reply To	What's the trick for the intake gaskets? posted by tixxit on June 14, 2018 at 11:02 PM
Message	vertical (ie., in the corners) apply a dab of RTV. The factory manual (can be found online) shows as well. RTV helps to assure a good seal. FYI - Permatex Ultra Copper is my number one choice.
Follow Ups	8mm water line plugs - where to find them? - 300NASeattle 17:02:59 06/11/18 Pretty normal to have oil mist deposits in upper plenum. - jzack 18:02:11 06/11/18 Forgot to add — not unusual to have the EGR tubes that - jzack 18:09:07 06/11/18 Thanks for the help. I had the valve cover gaskets replaced - 300NASeattle 20:19:46 06/11/18 Fyi - NO exhaust gaskets. It’s just RTV, hopefully that was - jzack 23:33:12 06/11/18 What's the trick for the intake gaskets? - tixxit 23:02:59 06/14/18 For any location where the direction of the gasket goes - jzack 23:34:14 06/14/18 I could not find any hose caps that were made of acceptable - 300NASeattle 13:45:49 06/17/18 FYI After searching for another issue I found the post that - 300NASeattle 20:13:42 06/23/18
Post a Followup	You cannot reply to this message because you are not logged in.