Subject	Thing that makes me think that isn't it is...
Posted by	GrecV2 on April 19, 2018 at 2:19 PM
	This message has been viewed 332 times.
In Reply To	Possibly a vacuum leak somewhere posted by LitlElvis on April 19, 2018 at 09:22 AM
Message	... the fact that I just completed a plenum pull where evert port was disconnected and re-connected. (all plenum gaskets, pipe-threaded vacuum trees, etc. as well) and I still have the same problem that I had before the pull... UNLESS one of the vacuum lines has a hole in it somewhere. I Also re-set the TB cables / butterflies and they are not sticking and are properly set. From all the feedback, I'm thinking IACV related... Good news it that she is running amazing aside from this issue. :-) Former Stage V addict... off the wagon.
Follow Ups	Revs not dropping immediately to idle... - GrecV2 09:37:49 04/17/18 Re: Revs not dropping immediately to idle... - Bigmatthew86 11:10:56 04/17/18 Haven't checked that, although... - GrecV2 15:14:24 04/17/18 Also not a bad idea to verify the throttle cable isn't - jzack 11:18:40 04/17/18 Very True. I have also seen the PCV hard pipes that come - MixManMash 13:48:20 04/17/18 I just re-did / adjusted TBs / cables. They close fully. (n/m) - GrecV2 14:36:20 04/17/18 jeezus.... that could end badly. (n/m) - MeatMan (604Z) 17:49:51 04/17/18 Yep. Happened to me during a full throttle, full boost run. - MixManMash 08:06:59 04/18/18 Heh. I had linkage on my triple carbs disconnect one time... - GrecV2 16:50:35 04/18/18 I had this happen at highway speeds as well. (n/m) - spicyZ 11:12:56 04/23/18 Plug off your Cold Start Air Regulator. - Cjw3 17:29:16 04/17/18 I did that as well, first as a trouble shooting test; but I - Gordo 96NA Daytona 21:15:22 04/17/18 I'll take a look at this... - GrecV2 21:47:42 04/17/18 It sounds like an issue similar to one I had with my old TT - Gordo 96NA Daytona 21:02:20 04/17/18 Heh. One of the things that I just did was swap ECUs... - GrecV2 21:46:08 04/17/18 Lucky You. ;-) (n/m) - Gordo 96NA Daytona 21:57:38 04/17/18 Re: Revs not dropping immediately to idle... - Metacom 20:10:35 04/18/18 Re: Re: Revs not dropping immediately to idle... - 1996 Z32 N/A 06:12:12 04/19/18 Re: Re: Re: Revs not dropping immediately to idle... - Metacom 07:18:10 04/19/18 Insure Throttle Bodies and Butterfly Plates are carbon free. (n/m) - Gordo 96NA Daytona 08:49:19 04/19/18 Possibly a vacuum leak somewhere - LitlElvis 09:22:08 04/19/18 Thing that makes me think that isn't it is... - GrecV2 14:19:43 04/19/18 Re: Thing that makes me think that isn't it is... - Metacom 19:31:36 04/19/18 Spraying starter fluid is a quick and clean way to find or - LitlElvis 18:56:52 04/20/18 Did you check the Air regulator? - rightzedfred 23:02:14 04/19/18 That's the one right next to IACV, right? (n/m) - GrecV2 09:37:18 04/20/18 Yes I believe it is near it. - rightzedfred 07:38:40 04/21/18 Yep. That's the one (n/m) - GrecV2 19:09:12 04/21/18
Post a Followup	You cannot reply to this message because you are not logged in.