Subject	Your kit should come with new idler studs
Posted by	BlackholeZ on January 31, 2018 at 6:53 PM
	This message has been viewed 276 times.
In Reply To	Bolts and nuts posted by irdhp78 on January 31, 2018 at 12:54 PM
Message	There's been a little research lately that they probably don't need to be replaced, but they're not expensive to do. Last two belts I've done I've ordered the rubber grommets for the timing belt cover screws. They tend to get hard and brittle. -Dan "Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse." "'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr "full alphabetic boost mode" - ChristopherTheOne " Purrs like a sexually satisfied black panther." - BigTDogg "Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines
Follow Ups	Bolts and nuts - irdhp78 12:54:03 01/31/18 Your kit should come with new idler studs - BlackholeZ 18:53:57 01/31/18 The seals between front plastic covers and the rear - JMartz 06:43:36 02/01/18
Post a Followup	You cannot reply to this message because you are not logged in.