TwinTurbo.NET: Nissan 300ZX forum - Don't have any first hand experience, but there was a tech
Subject
Don't have any first hand experience, but there was a tech
Posted by
Tanley (ATL)
on November 29, 2017 at 3:09 PM
This message has been viewed
320
times.
In Reply To
Forget to Have Machine Shop Pull Oil Check Valves
posted by Joe@Dewla_DeZign
on November 28, 2017 at 08:00 PM
Message
article on removing them and it was noted that there might be a lot of metal shavings in the center of the block after machining. I think there were pictures at one point, maybe email KongZTT and see if he can rehost the pictures.
Follow Ups
Forget to Have Machine Shop Pull Oil Check Valves
-
Joe@Dewla_DeZign
20:00:09 11/28/17
Don't have any first hand experience, but there was a tech -
Tanley (ATL)
15:09:39 11/29/17
Yeah, I did see that one
-
Joe@Dewla_DeZign
23:11:58 11/29/17
I was going to say that I would pull apart and clean it, but
-
Tanley (ATL)
08:50:53 11/30/17
If you choose to leave them as is, I personally
-
Aaronw
21:57:03 11/29/17
Post a
Followup
You cannot reply to this message because you are not
logged in
.