Subject	Any recommendations in MN for an initial tune?
Posted by	ZUL8R on November 14, 2017 at 10:16 AM
	This message has been viewed 326 times.
Message	I just got the Z back together again. Been a 2 year project! I have a new engine from Kyle, and some other things. It started up fine but sounds a little rough. I have a specialty z eprom installed to match the mods. I wonder if anyone can recommend someone in Minnesota that can help with an initial setting of idle and ignition timing and whatever else (AFR?) I am not looking for a performance tune at this point - just want to have it running within specs. No error codes on the ECU after 10 miles. Seems to be running a little warm. Could a dealer do this initial check-up?
Follow Ups	Any recommendations in MN for an initial tune? - ZUL8R 10:16:32 11/14/17 what makes you say it sounds rough? (n/m) - Boostjuice 17:56:57 11/14/17 I guess it just seems loud. Maybe being paranoid. - ZUL8R 20:03:18 11/14/17 the wisecos are going to be noiser then stock pistons - Boostjuice 22:19:44 11/14/17 i have a built bottom end engine from kyle - Boostjuice 22:22:50 11/14/17 Thanks boostjuice. I will install the widebands tonight and - ZUL8R 11:53:33 11/15/17 I had Nissan check ignition timing after my rebuild - Zbruh92 01:22:22 11/15/17 Thank you. I gapped to .035". Stock gauge but have - ZUL8R 11:52:45 11/15/17 How much boost you runnin? - Zbruh92 15:10:10 11/15/17 the higher you go up in boost the smaller you want the gap - Boostjuice 20:09:06 11/15/17 You right I had it backwards, excuse my human (n/m) - Zbruh92 23:23:18 11/15/17 SZ chip is as close to perfect, w/o a full tune..... (n/m) - The Hawk 10:07:23 11/16/17 Thanks everyone. Seems to be smoothed out. No codes. (n/m) - ZUL8R 10:46:25 11/16/17
Post a Followup	You cannot reply to this message because you are not logged in.