TwinTurbo.NET: Nissan 300ZX forum - Re: Spoke with Ormes Brothers - they do Nelson Racing Engines
Subject
Re: Spoke with Ormes Brothers - they do Nelson Racing Engines
Posted by
Rob260
on October 28, 2017 at 6:54 AM
This message has been viewed
240
times.
In Reply To
Spoke with Ormes Brothers - they do Nelson Racing Engines
posted by Zbullet
on October 25, 2017 at 11:08 AM
Message
Cool let us know how that tool goes with flaring SS... I was looking at a mastercool pneumatic flaring Tool a while back but goddam the cost starts to add up with flaring tools, ridgid bending tools etc...
Follow Ups
Anyone ever fab custom SS hard lines
-
Zbullet
22:50:04 10/19/17
Swagelok FTW. I personally hate AN fittings with a passion.
-
MixManMash
01:37:42 10/20/17
I love the swagelok stuff but it's obv very pricey
-
Zbullet
09:05:08 10/20/17
Re: Anyone ever fab custom SS hard lines
-
Rob260
23:15:43 10/20/17
I have sh!t loads of Aluminum fittings on hand (n/m)
-
Zbullet
23:28:50 10/20/17
Re: Anyone ever fab custom SS hard lines
-
TheKryptKeeper
10:03:55 10/22/17
Where did you get the raw aluminum lines? (n/m)
-
ZXoltan
12:23:19 10/23/17
Re: Where did you get the raw aluminum lines?
-
TheKryptKeeper
10:01:15 10/29/17
Spoke with Ormes Brothers - they do Nelson Racing Engines
-
Zbullet
11:08:57 10/25/17
Re: Spoke with Ormes Brothers - they do Nelson Racing Engines -
Rob260
06:54:41 10/28/17
Post a
Followup
You cannot reply to this message because you are not
logged in
.