TwinTurbo.NET: Nissan 300ZX forum - I was clutch in getting on the highway
People Seeking Info
 
   


     
Subject I was clutch in getting on the highway
     
Posted by BlackholeZ on October 25, 2017 at 11:32 AM
  This message has been viewed 265 times.
     
In Reply To At approx what RPM's was the engine at when the belt posted by FrozTTy on October 25, 2017 at 07:33 AM
     
Message maybe 2000 RPM. I know there are locations where the cams can stop without valves hitting pistons. I think the fact that my belt snapped instead of slipping and my low RPM allowed the cams to stop in an ideal location.

-Dan


"Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse."
"'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr
"full alphabetic boost mode" -
ChristopherTheOne

" Purrs like a sexually satisfied black panther." - BigTDogg
"Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.