Subject	Re: Engine whine
Posted by	brian913 on September 18, 2017 at 11:22 AM
	This message has been viewed 320 times.
In Reply To	Engine whine posted by infoschumi on September 17, 2017 at 04:35 AM
Message	My two cents. One very odd thing happend to me recently. When I was putting the crank pully back on, the woodruf key slipped out of its slot and was wedged between the outer flat washer and the back of the pulley. This resulted in the accessory belts being pushed outward enough for the belts to be out of alignment and whine. Kept time for some reason but once I finally figured out that the key was out of place, had dented the washer, and put it back in the correct place (with a new washer) things improved dramatically.
Follow Ups	Engine whine - infoschumi 04:35:15 09/17/17 Well it's definitely RPM related. It does concern me that - jzack 12:42:14 09/17/17 Re: Well it's definitely RPM related. It does concern me that - infoschumi 16:48:41 09/17/17 Did you remove the bolt from the tensioner after - MixManMash 21:09:05 09/17/17 Yes, tensioner arm stopper bolt should be removed. It's not - jzack 22:14:50 09/17/17 I agree from looking at the pictures. Likely that washer - MixManMash 07:12:39 09/18/17 Re: I agree from looking at the pictures. Likely that washer - infoschumi 16:04:53 09/18/17 Re: Re: I agree from looking at the pictures. Likely that washer - infoschumi 16:05:55 09/18/17 Ouch. Think you could epoxy that broken - MixManMash 18:44:18 09/18/17 Instead of trying to reattach the broken part maybe bend up - jzack 20:45:05 09/18/17 Re: Instead of trying to reattach the broken part maybe bend up - infoschumi 01:19:45 09/19/17 I have an oil pump you can have for cost of shipping - ZXoltan 10:37:11 09/19/17 Re: I have an oil pump you can have for cost of shipping - infoschumi 11:23:15 09/19/17 Please send me an email. - ZXoltan 15:42:18 09/19/17 The other thing is if the timing belt plate (the washer that - MixManMash 21:11:42 09/17/17 Re: Engine whine - brian913 11:22:33 09/18/17
Post a Followup	You cannot reply to this message because you are not logged in.