TwinTurbo.NET: Nissan 300ZX forum - Gasket matching MSP Manifolds
Subject
Gasket matching MSP Manifolds
Posted by
Master_Blaster
on September 09, 2017 at 1:44 PM
This message has been viewed
472
times.
Message
The holes on the OEM manifolds are smaller than the ports in my NsP manifolds. My first question is should I grind the gasket to match the manifolds? If so what is the best way to do this?
Follow Ups
Gasket matching MSP Manifolds -
Master_Blaster
13:44:23 09/09/17
Re: Gasket matching MSP Manifolds
-
EngineerLV
20:00:20 09/10/17
I think he's saying the gasket is smaller than the MSP port (n/m)
-
ZXoltan
16:14:06 09/12/17
It is
-
EngineerLV
20:33:00 09/12/17
Post a
Followup
You cannot reply to this message because you are not
logged in
.